IoT Sensors

Network tester: qualify and validate the IoT network

Make all your meters (water, gas, electricity…) communicate

Pulse: make your meters communicate in ATEX ZONE

Modbus interface: upload measurement and alert data

Wired sensor interface: connect 0-10V or 4-20mA sensors

Gas meters in ATEX zone: make them communicating

Gas meters in ATEX zone: make them communicating

Current: measure the electricity level with an ammeter clamp

Temperature | Humidity | Optimize comfort and consumption

CO2 | Temperature | Humidity: optimise Indoor Air Quality

Opening detection: check door openings / closures….

Dry contacts: monitor 0-1 status and control relays remotely

Dry contacts: reset states 0-1 and control relays remotely

Air pressure delta: monitor the condition of a building’s air network

Supervise the maintenance of ventilation systems

Temperature: measure, monitor and alert if thresholds are exceeded

Temperature: read simultaneously at two locations

Presence of water: detect a fluid at a specific location

Presence of water: detect a fluid at a specific location

Fluid level: check and be alerted when a fluid level changes

Indoor Air Quality | Monitoring of the well-being of occupants

Presence | Brightness: optimize comfort & consumption

Fine particles and TVOCs: optimising Indoor Air Quality

Sigfox Repeater: extend the range of the SIGFOX RC1 network

Sigfox Repeater Kit: extend the range of the SIGFOX RC1 network